6
<
<
I
I
M
M
P
P
O
O
R
R
T
T
A
A
N
N
T
T
N
N
O
O
T
T
E
E
>
>
For Naming the User Name, please
refer to section 5. Appendix, Naming
section for more information.
if the code is not correct, a
Code
incorrect
prompt message will be
displayed 2 sec., and you are
requested to repeat Step 2 to enter
again.
The code cannot be duplicated. If the
code has been used, the screen will
display
code in use
and require you
re-enter a new code.
To Edit Pin Code
After the Pin Code is programmed, it can be
edited by following the steps below:
Step 1
. Move the cursor to the
Pin Code
selection then
press
OK
.
D e l e t e p i n - c o d e
( O K ? )
Step 2
. Press key, the next screen will ask
you to enter your new PIN code and
repeat it for double confirmation.
Step 3
. Make your selection whether to have
the Latch Key Reporting ON or OFF,
and then press
OK
. The screen
returns to
Code Setting
menu, editing
the user PIN code is now completed.
To Delete User PIN code
Except User #1 which is activated by factory
default and can’t be deleted in any way,
User(#2~6) PIN code can be deleted by
following the steps below:
Step 1
. Move the cursor to the
PIN Code
selection then
press
OK
the following
screen will show the status of each
User PIN code:
* 1 ) M R . S M I T H
2 ) M R S . S M I T H
3 )
4 ) . . . . . .
Step 2
. Move the cursor to the desired # (2~6)
of programmed user PIN code to be
deleted, then
press
OK
the following
screen is displayed.
D e l e t e p i n - c o d e
( O K ? )
Step 3.
Press
OK
and the screen returns to
previous one with the deleted User
PIN code marked with
●●●●
2.1.1.2 Duress Code
The Duress Code is designed for
transmitting a secret & silence alarm.
When Duress Code is used for accessing
the system, the Control Panel will report a
secret alarm message without sounding
the siren to the Central Monitoring Station
to indicate of a
Duress Situation in
Progress
. The LCD will display in the
same manner as if operating with a User
PIN Code. There will be no Alarm! Alarm!
warning message, nor any siren sound.
The Duress Code consists of 4 digits and
is not activated as default by the factory.
To set/change the Duress Code, follow
the same steps as those to set
/change/delete the user PIN code
described in previous section.
2.1.1.3. Temporary Code
The temporary Code is also used to
arm/disarm the system for a temporary
user. It is
ONLY
valid for one-access per
arming and disarming. Afterwards, the
Temporary Code will be automatically
erased and needs to be reset for a new
Temporary user.
The Temp. Code consists of 4 digits and is
not activated as default by the factory.
Latch Selection must set as
Optional
Latch
(please refer to section 2.4.4
for
details), so that a Latch Report On/Off
selection will appear.
To set/change the temporary Code,
follow the same steps as those to set
/change/delete the user PIN code
described in previous section.
2.1.2 Master code
Master Code is used for accessing the