39
The fault message can only be cleared
manually after the fault condition has been
rectified.
3.13.3. Viewing/Clearing the Fault
Message
To check what the fault condition is,
Step 1.
When the system is in Alarm off mode.
Enter your PIN Code followed by
OK
.
Step 2.
The screen will display
F a u l t D s p
A r m
and the cursor stays at
Fault Dsp
Step 3.
Press
OK
to select
Fault Dsp
Step 4.
All the fault events are listed. Use
&
key to move the cursor
downwards or upwards. The screen
is also scrolled down or up
respectively.
Step 5.
After viewing all the fault events, press
key, a prompt message is displayed.
C l e a r F a u l t
D s p : ( O K ? )
Step 6.
Press
OK
, then the fault event, which
the fault condition has been rectified,
will be cleared and the screen returns
to
Alarm off
.
<
<
N
N
O
O
T
T
E
E
>
>
In
Step 6
, if
key is pressed, the
screen returns to
Alarm off
, the
Yellow LED stays on, the Control
Panel keeps sounding a short beep
every 30 seconds, and the fault event
display retains.
If the fault condition has not been
rectified, the fault event display will not
be cleared. It will come on again
while you try to arm the system and
the faulty condition inhibits the system
from being armed, then the fault
message will be displayed again. The
fault event display can be cleared only
after the fault condition has been
rectified.
Even when the fault messgae is
cleared, the fault event is still retained
in
Log
.
3.13.4. Fault Event Response
When a fault condition is detected, in
addition to the fault display, the Control
Panel
will
also
respond
separately
according to the nature of the fault event.
AC Power Fail / Restore
When the AC power fails, the
yellow LED will light, the fault
message will be displayed and the
system will send a AC Power Fail
report via SMS message to the first
telephone number.
Whenever Tel number exists, and
power is restored from complete
power interruption (either restored
by AC or battery), the system will
send an AC Power Restore report
via SMS message to the first
telephone number in 5 minutes.
Control Panel Low Battery
<
<
I
I
M
M
P
P
O
O
R
R
T
T
A
A
N
N
T
T
N
N
O
O
T
T
E
E
>
>
30 minutes before powering on the
Control Panel, if the battery switch is
put on OFF position, the Control Panel
will not detect battery condition.
Any time the Panel battery Low is
detected, the Control Panel will
report via SMS message to the first
telephone number in 2 minutes.
However,
when
the
battery
restored, an
L.B. Restore
will be
reported via SMS message in
30min .
Panel Sabotaged
<
<
I
I
M
M
P
P
O
O
R
R
T
T
A
A
N
N
T
T
N
N
O
O
T
T
E
E
>
>
Please refer to 2.1.3.14 Tamper alarm
under section General Setting to set
the tamper alarm reporting method.
To restore the tamper alarm function,
hook the C-FENCCE HOME unit to
the wall mounting bracket again. Then
place it to a desired location.
If
Away Arm Only
is selected
under Tamper alarm function, when