EKOM DK50 4x2VT/M, User Manual

Page: 40 / 60

PRODUCT MAINTENANCE
NP-DK50-Nx2VTM-AD-EN-6_04-2022 40 04/2022
PRODUCT MAINTENANCE
18. PRODUCT MAINTENANCE
The operator shall secure the
completion of repeated testing
of the equipment at least once
every 24 months (EN 62353) or
at the intervals defined by the
applicable national regulations.
A record of the test results must
be made (e.g.: as per EN 62353,
Annex G), along with the
measurement methods.
The equipment has been designed and
manufactured to keep maintenance to a
minimum. The following work must be
performed to preserve the proper and reliable
operation of the compressor.
Unauthorised interference
hazard.
Repair work outside the
framework of standard
maintenance (see Chapter 18.1)
may only be performed by a
qualified
technician (an
organisation authorized by the
manufacturer)
or the
manufacturer’s customer
service.
Standard maintenance work
(see Chapter 18.1) may only be
performed by the operator’s
trained personnel.
Only use manufacturer-
approved replacement parts
and accessories.
Danger of injury or equipment
damage.
Prior to commencing
compressor maintenance, it is
necessary to:
- check if it is possible to
disconnect
the
compressor from the
appliance in order to
avoid any risk of injury to
the person using the
appliance
or other
material damage;
- turn off the compressor;
- disconnect it from the
mains (pulling the cord
out of the mains socket);
- vent the compressed air
from the air tank
.
Prior to commencing dryer
maintenance work, first:
- shut off the compressed
air supply to the dryer
- turn the main switch on
the
side of the
switchboard to the “0”
position;
- check the pressure
indicator on the dryer
and if there is still
pressure, it must first be
vented from the dryer
chamber.
Venting compressed air poses
an injury hazard.
Wear eye protection, i.e.
goggles, when venting
compressed air from the
compressed air circuit (air tank)
and from the dryer chamber.