EFKA SM210A5710
41
TECHNICIAN LEVEL
Parameter
Designation
Unit
max
min
Preset
Ind.
Prg.
No.
143
Ft2
Tape cutter function
1
0
0
A
0
=
Tape cutter until seam end
1
=
Tape cutter over time
(time setting with parameter 142)
149
FPL
0
=
Function Off
1
0
0
C
1
=
Puller is lifted together with the sewing
foot of the DC drive
(effective only in modes 8 and 9)
150
mPL
1
=
The puller is lifted when pressing a pushbutton
3
1
1
A
on input in8 or when the sewing foot is lifted.
2
=
The puller remains lifted until counting (parameter
000) has been completed. Counting can be
interrupted by pressing the pushbutton on input in8.
3
=
The puller is lifted at the seam end during thread
trimming. At the start of the next seam or after
power On, the puller is lowered after counting
(parameter 000). Counting can be interrupted
by pressing the pushbutton on input in8.
151
StP
0
=
Setting parameter 290 = 0...7
2
0
0
A
The connected main drive works in the chain
stitch or overlock mode. If the stitch condensing
signal is recognized, the stepping motor changes
its transmission ratio according to the setting
of parameter 070.
Setting parameter 290 = 8/9
The stepping motor rotates in cw direction
(no effect)
1
=
Setting parameter 290 = 0...9
If the DC drive rotates in cw direction in the
lock stich mode, the stepping motor also
rotates in cw direction. If the DC drive rotates
in ccw direction, e.g. during backtacking, the
stepping motor also rotates in ccw direction.
2
=
Setting parameter 290 = 0...7
Function as with setting 1
Setting parameter 290 = 8/9
If, on the DC drive, stitch condensing is switched
on in the chain stitch mode, the stepping
motor rotates in cw direction at the transmission
ratio that corresponds to the setting of parameter
070.
152
SbS
Function start tape tension
1
0
0
A
0
=
After “power On”, start with the tape tension
value last used.
1
=
After “power On”, start with tape tension
value 1 (value according to setting of lefthand
arrow above pushbutton 1 on the control panel).
153
RbS
Function reset tape tension
1
0
0
A
0
=
After a reset by means of the external pushbutton
on socket in7 or by pedal in pos. –2 (seam end of
the d.c. drive, if parameter 132 = 1), the last preset
value for adjusting the stepping motor is used after
readjustment of the reference point.
1
=
As with setting “0“, however, the value for
adjusting the stepping motor is determined by
parameter 051 (value according to setting of lefthand
arrow above pushbutton 1 on the control panel).
160
dci
Direc tion of rotation of the d.c. drive
1
0
0
A
0
=
cw rotation
1
=
ccw rotation
161
mdi
Adaptation of the stepping motor to the mounting
1
0
0
A
direction
