Software Overview
Pro 32r Operations Guide
73
1 Units: Various units of measure.
NOTE: Leave Measurement Units in metric.
2
Remaining Media Length:
Enables/disables the remaining
media length feature
•
Take-up length:
The Media length required to reach from
the Media Roll to the Feeder Shaft.
•
Feed length:
The length of Media required to reach from
the media Roll to the Free-fall Pistons.
3 The three printing modes: Roll-to-Roll, Free-Fall, Flatbed.
4
•
Skip White:
When checked, if there is a white section in
the file (without any data at all), the carriage rests and
the media advances until it arrives at the next pass
containing data. Printing then resumes from that point.
•
Add Job Label by default:
If checked, the job's label
with user-set options is printed at the end of each file. If
unchecked, no label is printed.
•
Job’s Label Font Size:
Determines labels’ font size.
•
Carriage Movement Margin:
Distance from the image
that the carriage will travel on the X-axis before and
after each pass. Distance can be adjusted on the fly.
• When printing on media that tend to heat during the
printing process, this margin gives more time to cool
down before the next pass.
5 Nozzle Test/Fire All: Set the Nozzle Test’s Print Speed.
6
Wrinkle Detector. Check to activate wrinkle detector .
•
Wrinkle Detect less than
: Determine the minimum
wrinkle height to alert for wrinkles.
•
Wrinkle detection handling
: When checked, the printer
automatically responds to any wrinkles by moving the
carriage up by a preset value.
7 General options to choose from.
8
Unattended Mode - not in use.
9 All sensors must be activated constantly.
10 Enable/disable End of Media sensors. Alerts when the media
detaches from the media roll. Must be activated constantly.
11 Job Queue
• New Job State: Status of new job – Hold/Waiting.
• Jobs Gap: The gap between jobs in mm.
• Add Job to the next available roll when printing multi-roll.
• Print resume option: If the printer stops for any reason, this
option enables the resumption of the printing from where
it stopped. (See
12 In-line Finishing
• Slitter Marks length
• Pause for Slitter Location: Determines the location of the
slitter mark on the Y-axis. The slitter mark should be
located between the print table and the T-roller.
(See
