32
Installation and Service Guide: Color Controller E-46A
Using the E-46A
Command WorkStation
As an E-46A service technician, you will typically log on to the system as Administrator. For more information about
using Command WorkStation, see
Command WorkStation Help
.
About Configure
You can access Configure from Command WorkStation or WebTools. For information about using Configure, see
Configure
Help
.
To access Configure from an Internet browser
1
Open an Internet browser and type the IP address of the E-46A.
Note:
As a security measure, WebTools is designed to work only over Hyper Text Transfer Protocol Secure (HTTPS).
By default, WebTools uses a self-signed certificate created by the Fiery. This causes the web browser to display a
untrusted certificate message while accessing WebTools. It is safe to ignore this message and proceed to access
WebTools.
2
In WebTools, click the
Configure
tab.
3
Log on with Administrator privileges.
To log on with the Administrator privileges, use the administrator’s password set by the site administrator.
To access Configure from Command WorkStation
1
In Command WorkStation, as Administrator, do one of the following:
•
Click
Server
>
Configure
.
•
Click
Server > Device Center > GENERAL > General Info tab
, and then click
Configure
in the lower right corner.
2
If the
Fiery Setup
dialog box displays, click
Configure
.
Fiery QuickTouch
The Fiery QuickTouch on the front of the E-46A allows you to do the following:
•
View print job status and alerts
•
Use Fiery System Restore to back up and restore the E-46A
•
Replace the motherboard (when the motherboard replacement dongle is inserted into a USB port)
•
View the IP address of the E-46A
•
Shut down, restart, or reboot the E-46A (see
).
•
Interact with the E-46A during software installation and initial setup (see
•
