Edwards nEXT 55, Instruction Manual

Page: 53 / 116

Object name
Command Parameter
range
Factory
setting
Data type Units
Comments
Power limit
setting
!S855 50..120 80 decimal Watts Link power maximum
?S855 - - - - -
Normal speed
setting
!S856 50..100 80 decimal % Normal speed as a per-
centage of full speed
?S856 - - - - -
Standby
speed setting
!S857 55..100 70 decimal % Standby speed as a per-
centage of full speed
?S857 - - - - -
Temperature
readings
?V859 0..100 - decimal °C Measured motor temper-
ature
0..100 decimal °C Measured motor control-
ler temperature
Link parame-
ter readings
?V860 0..500 - decimal 0.1 Volts Measured link voltage
0..300 decimal 0.1 Amps Measured link current
0..15000 decimal 0.1 Watts Measured link power
Pump run
hours
?V862 0..65535 - decimal hours Hours run by pump
Temperature
readings 2
?V865 -200..200 - decimal °C Measured motor temper-
ature
-200..200 decimal °C Measured motor control-
ler temperature
-200..200 decimal °C Measured rotor tempera-
ture
Factory set-
tings
!S867 1 - - - Reset all configuration
options and parameters
to the factory settings
PIC software
version
?S868 10 - string chars Boot loader software ver-
sion number
(D396596XXX)
Speed control !C869 0 - decimal - Set target speed to full
speed
1 - - - Set target speed to stand-
by speed
Timer options !S870 0 1 decimal - Timer = disabled
?S870 1 - - - Timer = enabled
Note that the timer is
permanently enabled on
ramp-up.
07/2021 - ©Edwards Limited Page 53 B8G000880_E
B8G000880_E - Installation