Versatrax 300™
Document: UMBH008532.docm
Revision: A07
Created by: KJB
Date: 26 Sep 2019
3047763-A07
Source Location: C:\ePDM\ISLEng\products\bh-vt300series4-trackchassis\manuals\UMBH008532.docm
Page 36 of 67
Versat
rax 30
0 User Ma
nu
al
For IB
A
5954
Inline Vehicle Configuration (6-8-10-12)
Installing the Tracks
FIGURE 27: INLINE TRACK MOUNTING SCREWS
Tools required to install the tracks and side plates onto the inline chassis: 5 mm T-Handle Allen wrench;
Large Phillips screwdriver.
Warning: Pinching Hazard.
Keep your fingers and hands out of the X-Hinge. Do not hold or lift
the vehicle by the X-Hinge. Severe pinching and hand injury may result. Always use the
handles for lifting.
1. The in-line vehicle shares all the modular components with the parallel vehicle. These
components must be removed for installation onto the in-line chassis:
•
4x Tracks
•
Main Spectrum camera and auxiliary crystal cameras.
•
Telemetry Can
•
Tether Termination can with brackets.
2. The wiring harness is not transferrable. Cabling for the in-line vehicle is much longer. The in-line
chassis has its own dedicated set of cables which can remain installed in the chassis.
3. The heat sink fins must be removed from the telemetry can.
2.
Place the vehicle on a suitably long work bench (minimum 15’ or 450 cm) with the tracks in the
orientation shown. In this way the tracks will both operate in the forward direction as they do for
the parallel configuration (no track reversal settings necessary in the controller). The far side
plates may remain attached to the handles and hinges as shown.
