Versatrax 300™
Document: UMBH008532.docm
Revision: A07
Created by: KJB
Date: 26 Sep 2019
3047763-A07
Source Location: C:\ePDM\ISLEng\products\bh-vt300series4-trackchassis\manuals\UMBH008532.docm
Page 29 of 67
Versat
rax 30
0 User Ma
nu
al
For IB
A
5954
FIGURE 18: INSIDE TRACK WEIGHT - WIRE ROUTING
Camera Raise Extension
The Camera Raise Extension is an optional bolt-on bracket which raises the camera by 14 inches. To
install the bracket, refer to DWG ADAI0030:
1. Remove the camera, handle and bumpers from the vehicle and install them on the extension
bracket. The top of the extension bracket is made the same profile as the original camera mount.
2. Bolt the extension bracket onto the original camera mount using two ¼-20 x 1in socket cap bolts
from the back and one 3/8-16 x 1¼in bolt from the front. The height of the bracket can be
adjusted to six different positions.
3. Mount the camera and lights as usual on the raise bracket.
4. Install the supplied wiring harness extension to the camera. Whips for the sonar and lights have
already been made long enough to accommodate the camera extension.
5. The auxiliary camera can be mounted to either side of the extension as shown. The curved slots
in the camera mounting bracket enable the camera to tilt up or down for best viewing angle. See
the section above for camera installation.
