Versatrax 300™
Document: UMBH008532.docm
Revision: A07
Created by: KJB
Date: 26 Sep 2019
3047763-A07
Source Location: C:\ePDM\ISLEng\products\bh-vt300series4-trackchassis\manuals\UMBH008532.docm
Page 32 of 67
Versat
rax 30
0 User Ma
nu
al
For IB
A
5954
•
At the other end of the cable trough the wires plunge down into the middle hinge and reemerge at
the front chassis. The two cables for the rear tracks branch off before the hinge and enter the rear
chassis.
•
The two cables for the front tracks branch off after the mid-hinge and enter the front chassis.
•
Figure 22 illustrates how the track whips are routed and constrained inside the chassis. In (1) the
bottom support bar is removed to show the cable loop. The cables enter the chassis from the
harness bundle, make a complete upwards loop and attach to the butterfly hinges with cable clips
before entering the tracks. In (2) another set of clips are used to secure the bottom of the loop.
An extra coil (3) may be used to accommodate the extra track length needed for the track
extensions.
•
Cables for the main camera, lights and sonar enter the front cable guide and exit behind the
camera.
FIGURE 22: CHASSIS CABLE ROUTING
