Versatrax 300™
Document: UMBH008532.docm
Revision: A07
Created by: KJB
Date: 26 Sep 2019
3047763-A07
Source Location: C:\ePDM\ISLEng\products\bh-vt300series4-trackchassis\manuals\UMBH008532.docm
Page 17 of 67
Versat
rax 30
0 User Ma
nu
al
For IB
A
5954
Minitrac
™ Installation & Removal
1. The chassis must be in the flat configuration for installation of the tracks.
2. Use the track installation stand provided with the vehicle to hold the chassis while installing the
tracks. Place the jack blocks onto the stand and set the chassis on top. The tapered end of the
stand is at the back of the vehicle.
3. Place the tracks in position around the vehicle.
4. Place the 2x4 spacing blocks under the tracks if you are not using the track extension brackets.
5. Install the outside flanges first using ¼-20 x 5/8in socket cap screws. Leave the screws slightly
loose until the inside bracket bolts are installed (step 7).
6. Plug in all four connector whips.
7. Bolt on the inside brackets using ¼-20 x 1¼in socket cap screws. The inside bolts may be difficult
to align. You may need to jiggle or lift up on the chassis to find the bolt alignment.
Tether Hook-Up
The photo sequence below shows the procedure for hooking up the tether.
1. The bottom flange remains with the tether termination can; the top flange remains with the
vehicle. The harness whips remain installed through the top flange as shown. It is best to keep
the mounting screws with the can.
2. Mount the can onto the back swivel and screw on the top flange. Make sure top and bottom
screws are tightened.
3. Plug in the connectors, including the Crystal Cam® connector. Make sure connectors are seated
all the way.
4. Install the rear camera bracket
5. Check that the tow cable is securely attached to the termination can.
1
2
