Versatrax 300™
Document: UMBH008532.docm
Revision: A07
Created by: KJB
Date: 26 Sep 2019
3047763-A07
Source Location: C:\ePDM\ISLEng\products\bh-vt300series4-trackchassis\manuals\UMBH008532.docm
Page 16 of 67
Versat
rax 30
0 User Ma
nu
al
For IB
A
5954
Vehicle Handling Equipment
Boom Arm & Cable Hoist
Because the vehicle is heavy some handling equipment is recommended with the system installation.
•
The first of these is a swinging overhead boom for vehicle deployment which must hold the pay-
out sheave axle at least 9 feet above ground level. The capacity of the arm needs to be at least
½-tonne at full extension
– enough for full vehicle weight plus full winch power.
•
The pay-out sheave diameter should be at least 10in diameter to help prevent tether fatigue.
•
An electric cable hoisting winch with at least ½-tonne load capacity is necessary to raise and
lower the vehicle. The cable on this hoist needs to be long enough for the deepest expected
deployment.
Configuration
Configuration Bench
You will need a dedicated work bench for vehicle configuration and maintenance. Ideally this is at least
30in x 60in and is accessible from both sides. The lower portions of the bench may be equipped with
racks or drawers where tools, spare parts and fasteners are kept.
A configuration fixture is provided with the VT300. This is a system of wooden stands and support blocks
used for installing the tracks, side weights and track extension plates.
Parallel Vehicle Configuration
FIGURE 4: VT300 FOUR-TRACK CHASSIS
