EC POWER XRGI 20G-TO, Manual

Page: 76 / 168

76
Version 1.0 - 2012 Manual XrGi 20G-To
If a reference meter to meter the property’s heat requirements is installed and switched on, the menu will show the Power
load profile item. Otherwise the menu item Heat Controlled will appear at this point (see next section).
4.1.9. load profiles and heat-controlled
If the installation has only one power tariff, select high tariff for all 24 hours in the day, as shown below.
If there is more than one tariff, enter the start and end times for the HT periods (HT).
There are three period options: All working days
Saturdays
Sundays
Typical inputs:
Start: End:
24-hour high tariff 0:00 23:59
HT during specific periods 6:00 21:00
No HT within 24 hours 0:00 0:00
The control system optimises heat and power production based on the times entered.
Should the XRGI preferably be used to cover peak power loads at certain times of day, these times can be programmed here
as high tariff periods. Use the heat backup settings to select whether to use the XRGI outside peak loads or not.
Eingabe:
Use the keys to move the cursor to the time you want to change then press OK . The cursor now flashes on the hours
figure.
Use the
keys to change the hours and press OK . The cursor now moves to the minutes figure.
Use the keys to change the minutes and press OK to complete.
Use the ESC key to go back from minutes to hours.
Use the same procedure to change all times that need to be changed.
Move cursor to Save and press OK to save.
Changes will take effect a few seconds after they are entered. Settings can be changed at any time, even in automatic
operation.
4.1.8.2. HT period