NZM-XDMI-DPV1
(PROFIBUS-DPV1 Interface for
DMI)
156
11/04 MN01219002Z-EN
04
Trip
I
dn
the permissible residual current was exceeded and
has caused a trip
05
Overtemperature
the permissible operating temperature of the NZM
electronic circuitry was exceeded and has therefore
caused a trip
06
Overload range 1
the current in at least one phase has 100 % of the
permissible value
07
Overload range 2
the current in at least one phase has reached 120 %
of the permissible value
08
Loud prewarning
the current in at least one phase has exceeded 70 %
of the permissible value
09
Unbalance
an unsymmetrical phase current load exists
10
Parameter
comparison
the parameters in DMI (parameters used) and NZM
(locally set parameters) differ
11
Trip
a trip has occurred (independent of the trip cause)
12
Alarm
an alarm state has occurred (independent of the
alarm cause)
13
Motor prot.
the circuit-breaker (type -ME) detects an overload
and asks the DMI to disconnect the motor. If the
overload continues, the circuit-breaker will trip.
14
Bus access
the output is switched via the PROFIBUS-DP
15
Off
the output is permanently deactivated
16
On
if the output is permanently activated
Value for output
assignment
(decimal)
Switching signal
Output switches, if
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
