![background image](http://html1.mh-extra.com/html/eaton/easy500-easy700/easy500-easy700_operating-instructions-manual_3938169013.webp)
1
1.1 Target group
Operating instructions
05/10 MN05013003Z-EN
www.eaton.com
9
1
1.1 Target group
easy must only be installed and connected up by trained electricians or other
persons who are familiar with the installation of electrical equipment.
Specialist electrical training is needed for commissioning and creating circuit
diagrams. When active components such as motors or pressure cylinders
are controlled, parts of the system can be damaged and persons put at risk if
the MFD device is connected or programmed incorrectly.
1.2 Proper use
easy is a programmable switching and controlgear and is used as a
replacement for relay and contactor control circuits. easy may only be
operated when it has been correctly and properly installed.
•
easy is designed to be installed in an enclosure, switch cabinet or service
distribution board. Both the power supply and the signal terminals must
be laid and covered so as to prevent accidental contact.
•
The installation must comply with regulations for electromagnetic
compatibility EMC.
•
The power up of easy must not cause any hazards arising from activated
devices, such as unexpected motor startups or power ups.
1.2.1 Improper use
easy should not be used as a substitute for safety-related controls such as
burner or crane controls, emergency-stop or two-hand safety controls.
Summary of Contents for easy500, easy700
Page 4: ...II...
Page 28: ...1 1 5 operating principles 24 Operating instructions 05 10 MN05013003Z EN www eaton com...
Page 210: ...7 What Happens If 7 3 Event 206 Operating instructions 05 10 MN05013003Z EN www eaton com...
Page 234: ...9 Glossary of terms 230 Operating instructions 05 10 MN05013003Z EN www eaton com...