Configuration Using the PROFIBUS Configuration File
20
C441 PROFIBUS Module User Manual
MN042002EN—July 2015
www.eaton.com
Enable Phase Reversal trip
S611
0 = disable fault
1 = enable fault
Enable Overload on start trip
S611
0 = disable fault
1 = enable fault
Enable Shorted SCR trip
S611
0 = disable fault
1 = enable fault
Enable SCR Not Firing trip
S611
0 = disable fault
1 = enable fault
Enable Over Temp trip
S611
0 = disable fault
1 = enable fault
Enable GND Fault trip
S611
0 = disable fault
1 = enable fault
Jam Trip Level
S611
Current threshold setting for Jam fault. (valid only during bypass 150–400% rated motor fla)
Jam Trip Delay
S611
Length of jam condition before fault in sec. (1–20)
Stall Trip Level
S611
Current threshold setting for Stall fault. (valid only at end of start ramp 150–300% rated motor fla)
Residual GF Trip Level
S611
Current threshold setting for GND fault trip. (in 0.1A) (1–100)
Residual GF Trip Delay
S611
Length of GND fault condition before fault in sec. (1–20)
Residual GF Start Delay
S611
Length of time from start to mask fault. (0–20sec)
Current Unbalance Trip Level
S611
Current Imbalance fault threshold. (1–20%)
Current Unbalance Trip Delay
S611
Length of current imbalance condition before fault. (1–20sec)
Load Disconnect Trip Level
S611
Load disconnect fault threshold. (% motor fla: 1–50%)
Load Disconnect Trip Delay
S611
Length of load disconnect condition before fault. (1–60sec)
Load Disconnect Source
S611
Low Power
Low Current
Phase Loss Trip Level
S611
Phase loss fault threshold. (% motor fla: 0–100%)
Phase Loss Trip Delay
S611
Length of phase loss condition before fault. (1–20sec)
Start Control Level or Edge
S611
S611 input configuration
0 = Edge triggered inputs
1 = Level triggered inputs
Fault Relay Configuration
S611
S611 fault relay configuration—relay output enabled when:
0 = Faulted
1 = Not Faulted
Aux Relay Configuration
S611
S611 aux relay configuration—relay output enable when:
0 = Faulted
1 = Not Faulted
2 = in Bypass
3 = Not in Bypass
4 = Motor Energized
5 = Not Motor Energized
User UI Edit Lock
S611
Lock S611 User interface module. (Prohibits changing S611 settings from UI)
0 = unlocked
1 = locked
Comm loss Timeout in milli-seconds
S611
Length of comloss before fault. (in .001 sec: 1–65000)
Comm loss behavior
S611
1 = Fault
2 = Hold Last State
3 = Stop
S611 ComLoss Enable
S611
0 = disable fault
1 = enable fault
Table 19. S611 Soft Starter Configuration File, continued
Parameter Name
Location
Notes
