10
Cabling conduits height:
Trim the conduits off where the ends are level
with the top of the baseplate. If any part of the
conduits protrude above the top of the basepate,
it will be difficult to adjust the position of the gearbox
on top of the baseplate.
How to use the manual release.
Move gate open and closed by hand
.
1. Unlock the manual release lever lock using the key supplied.
2. Swing the manual release lever upright to disengage the
gearbox.
To re-engage the gearbox lower the manual release lever and lock it once again. Gently pull or push the gate by hand until the gears fall into
place before triggering the unit to run.
Referencing the closed position
On the first trigger subsequent to the gearbox being engaged after a manual release, the gate will close at half speed. The system is looking for the
closed position which is the origin point. This is known as referencing the closed position. If any of the trigger inputs are activated or the safety
overload sensing is activated while the gate is busy “referencing” then the gate will simply stop. The next trigger will cause the unit to continue
“referencing”. While referencing the closed position the display will show
ref
. Referencing the closed position will also occur on the first trigger
after exiting programming or powering up a previously programmed control card.