Dynapac CA282D, Instruction Manual

Page: 58 / 119

Operation
ICA282-1EN3.pdf 2012-06-18
35
36
39
42
Fig. Control panel
35. Speed selector, drum/wheels
(Optional)
36. Speed selector, wheels
39. Forward/Reverse lever
42. Parking brake knob
Deactivate the parking brake knob (42) and check
that the parking brake warning lamp is off.
Remember that the roller can start rolling, if it is on
a slope. Deactivate the parking brake knob (42) and check
that the parking brake warning lamp is off.
Remember that the roller can start rolling, if it is on
a slope.
Set the High/Low speed selectors (35) and (36) to the
desired mode, see decal on the control panel.
Maximum speed Maximum speed
Low drum/Low rear axle 5.0 km/h Low drum/Low rear axle 5.0 km/h
Low drum/High rear axle 9.0 km/h Low drum/High rear axle 9.0 km/h
* High drum/Low rear axle 6.5 km/h * High drum/Low rear axle 6.5 km/h
* High drum/High rear axle 16.0 km/h * High drum/High rear axle 16.0 km/h
*Only with accessory *Only with accessory
The High/High mode may only be used for
transport runs on an even surface. The High/High mode may only be used for
transport runs on an even surface.
Carefully move the forward/reverse lever (39) forwards
or backwards, depending on which direction of travel
is required. The speed increases as the lever is moved
away from the neutral position.
The speed should always be controlled using the
forward/reverse lever and never by changing the
engine speed. The speed should always be controlled using the
forward/reverse lever and never by changing the
engine speed.
Check the parking brake by activating the parking
brake knob (42) while the roller is slowly moving
forward. Check the parking brake by activating the parking
brake knob (42) while the roller is slowly moving
forward.
48