PROTOCOL
Select the proper protocol of the connected PTZ camera. This field does not apply if the camera is
connected to the NVR over the network via the OnVIF protocol.
BAUD RATE
Select the baud rate level from 2,400bps up to 57,600bps. This field does not apply if the camera is
connected to the NVR over the network via the OnVIF protocol.
ADDRESS
Set the P/T/Z driver address of the connected camera. It should be the same as that of the PTZ. This
field does not apply if the camera is connected to the NVR over the network via the OnVIF protocol.
CONTROL(The functions depends on the camera’s model and supported features)
When the
[SET] button is clicked, the OSD menu of the camera will appear on the monitor. Set the
PTZ’s speed, preset, tour, auto-pan, etc.
Direction buttons: move camera up/down & left/right.
M (depends on the PTZ model): Show/ hide the camera’s OSD
menu on the NVR monitor. Use the directional arrows to navigate
the menu options.
ZOOM/FOCUS/IRIS: Control IN (+)/OUT (-) for each function.
(Depending on the camera’s model and supported features).
Speed: Change the PTZ speed (0~100). This sets the speed at
which the camera will move when controlled from the NVR using
the virtual joystick. Save the changes by clicking [SET].
Preset
•
ADD: Move the camera’s position and zoom to the
desired position. Select the preset number using the
button. Press [ADD] to save the
new preset. (The system supports preset the number of presets from 1 to 255.)
•
DEL: delete the preset currently selected.
•
Move: Enter a present number and press [Move] to move the camera to the preset
position of that number.
TOUR: Set the camera to move between preset positions in order. The
camera will keep running the tour until it manually is disabled.
AUTO-PAN: Set the camera to move 360 ° in one direction. The camera
will keep running the auto-pan until it manually is disabled.
GUARD-TOUR: Set the camera to move between selected presets in a set
order and interval. The camera will keep running the guard tour until it is
manually disabled.
•
Set: Set the Interval (Sec) and select the preset position. Add to
Sequence by clicking the
button. The preset will appear in the Sequence column
indicating the preset number and the set interval time.
•
Delete: To delete a preset position from the sequence, select the preset in the Sequence
column and click the
button.
•
MOVE: Start GUARD TOUR.
HOME: Set the camera to move to an original position memorized by the camera.
In case the PTZ is directly connected to the rear panel of NVR, the AUX control button
(
) is shown. Users can control additional settings such as Power, Light, Wiper and
Pump, etc.
