Introduction to the CB-5222 Analytic Bullet IP Camera
7
3.2.3
Waterproofing the Camera Cable Connectors
Follow the instructions below to waterproof the connectors for the different types of cables included
in the system cable. The cables are shown below.
System Cable
IP66 RJ45 Cable
Figure 6: Camera Cables
System Cable
To waterproof the system cable
1.
Connect all the required devices to the system cable.
2.
Coat the joints with silicone gel. There should be no gap between the connectors and the
cables. For alarm I/O connector and power connector, make sure the side with wires
attached is also sealed with silicone gel.
Figure 7: System Cable
3.
Seal the end of the rubber coating of the system cable as indicated in the figure below. Use
enough silicone gel to fill in the hose and wrap around each wire in order to properly
waterproof the cable.
Figure 8: System Cable Hose and Wiring
