Dürkopp Adler 650-16, Operating Instructions Manual

Page: 75 / 150

Control with the OP7000 control panel
Operating Instructions 650-16 - 02.0 - 08/2016 73
6.5.2 Sewing process
1. Set the fullness (

p. 71 ).
2. Set the curve support.
3. Input the values for needle thread tension and stitch length .
4. Push the pedal forwards and sew.

The length in mm sewn in the seam is displayed.
When the thread is cut off, the display is reset.
Changing parameters during the seam
1. Move the pedal to the 0 position.
2. Change the desired parameter on the control panel (

p. 70 ).
3. Push the pedal forwards and sew.

The seam will be sewn using the altered parameter value.
Parameters Meaning
Needle Stop Position Up When sewing stops the needle position is
up (activated) or down (not activated)
Foot Stroke Alternation Presser foot alternation whilst the needle is
in the seam
Value range: 0 ... 2.5 mm
Foot Pressure Presser foot pressure
Value range: 1 ... 10
Backtack at Start Backtack at start of the seam on (activa-
ted) or off (not activated)
Backtack at End Backtack at end of the seam on (activated)
or off (not activated)
Thread Trim Thread cutoff at end of the seam on (acti-
vated) or off (not activated)