Dürkopp Adler 650-16, Operating Instructions Manual

Page: 114 / 150

Setup
112 Operating Instructions 650-16 - 02.0 - 08/2016
7. Screw on the strain relief (7)
(chipboard screws 3.5 x 17).
8. Screw on the additional control (8)
(chipboard screws 5 x 30).
9. Screw on the DAC motor control incl. protective plate (9) (chip-
board screws 5 x 30).
10. Screw on the cable duct (40 x 40 x 250 mm long) (10)
(chipboard screws 3.5 x 17).
11. Fit the electric cables (

p. 118 ).
Larger scale diagrams can be found in the Appendix (

p. 143 ).
8.5 Completing the table top
Fig. 72: Completing the table top
To complete the table top:
1. Insert the oblique fittings (4).
2. Insert the rubber corners (5) into the table top.
3. Using 4.5 x 15 (4x) screws, screw on the hinge mountings (2).
4. Using 4.5 x 55 (8x) screws, screw the edge strips (3) to the
table top.
5. Insert the upper part support (1).
(1) - Upper part support
(2) - Hinge mountings
(3) - Edge strips (4) - Oblique fittings
(5) - Rubber corners
③
④
① ② ⑤