2-25
12H-M12M0-0309-0
(16) Folding plate motor test (Code No.22)
Mode for checking operations of the motor for moving the folding stoppers of folding plate 1 and 2.
Pressing the “+” key of the folding plate 1 folding stopper adjusting key rotates the folding plate 1 motor, and
moves the folding stopper in the reverse home position direction. Pressing the “–” key rotates the folding plate 1
motor, and moves the folding stopper in the home position direction.
Pressing the “+” key of the folding plate 2 folding stopper adjusting key rotates the folding plate 2 motor, and
moves the folding stopper in the reverse home position direction. Pressing the “–” key rotates the folding plate 2
motor, and moves the folding stopper in the home position direction.
The motor rotates while the key is pressed, and stops when the key is released.
As the motor rotates regardless of the limit detection by the home sensor and index sensor, make sure
that the folding stopper does not clash into the limit section of the folding plate.
The motor will not rotate if any one interlock switch is not closed.
Note
Note
(17) Stacker roller moving motor test (Code No.23)
Mode for checking operations of the stacker roller moving motor.
Pressing the “+” key of the folding plate 2 folding stopper adjusting key rotates the stacker roller moving motor,
and moves the stacker roller outside. Pressing the “–” key rotates the stacker roller moving motor, and moves the
stacker roller inside.
The motor rotates while the key is pressed, and stops when the key is released.
Pressing the “+” key continuously moves the stacker roller outside the unit and locks the motor.
The motor will not rotate if any one interlock switch is not closed.
Note
Note
(18) Paper feed clutch test (Code No.25)
Mode for checking the operations of the paper feed clutch.
The paper feed clutch operates when the start key is pressed, and stops when the stop key is pressed.
Do not leave the unit with the clutch operating. Otherwise, the clutch will overheat, resulting in malfunction.
Note
Note
(19) Paper ejection clutch test (Code No.26)
Mode for checking the operations of the paper ejection clutch.
The paper ejection clutch operates when the start key is pressed, and stops when the stop key is pressed.
Do not leave the unit with the clutch operating. Otherwise, the clutch will overheat, resulting in malfunction.
Note
Note
(20) Simulation mode (Code No.27)
Mode for operating each mechanism without using paper.
The simulation mode operates when the start key is pressed, and stops when the stop key is pressed.
If operating the unit in the simulation mode, be sure to remove the paper feed ring.
Note
Note
(21) Folding stopper parallelity mode (Code No.28)
Mode for making the folding stoppers of folding plates 1 and 2 parallel.
“2-6-10. Adjusting the parallelity of the folding stoppers” in CHAPTER 1 MECHANISM
(22) Sensor check (1) (Code No.31)
Mode for checking the states of each sensor.
At the 7-segment window on the right side, sensors which are ON are displayed as “1” and those which are OFF
are displayed as “0”.
The display corresponds to each sensor in the following order.
Paper feed inlet sensor
→
Paper ejection outlet sensor
→
Paper switch
→
Paper feed tray set switch
Turning ON/OFF the sensors changes the corresponding display (“1” or “0”) and a buzzer sounds.
See
See
