Duplex Jeti DS-12, Manual

Page: 17 / 151

computer radio control system EN
4.3 Control Stick Assembly
When handling with back cover removed always
switch off the transmitter and disconnect the
battery (unplug the connector). Also do not connect
the charging adapter or the USB cable.
Note:
Restrict your contact with the printed circuit
boards to a minimum. You can damage your
radio by electrostatic discharge!
Warning:
4.3.1 Control Stick Length Adjustment
The stick length is adjustable to suit your flying style. The stick end
separates into two parts.
1. Hold the top part of the
stick and firmly and unscrew (turn it
anticlockwise).
2. Turn the stick end clockwise to
shorten or counterclockwise to
lengthen the overall stick length.
3. Adjust the lower part to support
the top part of the stick end.
4. Finally secure by tightening both
parts to each other.
If you have installed optional sticks with switch or
button ends; make sure that while adjusting the stick
length you observe the wires that pass through the
stick shaft and through the gimbal opening in order
to prevent damaging the connecting cables. The
safest method is to remove the small set-screw from
the side of the stick housing to allow the switch or
knob internals to remain stationary while you rotate
the stick housing for height adjustment. (4.3.7)
Warning:
4.3.2 Control Stick Angle Adjustment
It isn't possible to adjust the angle of rotation of control stick in the
DS-12 transmitter.
2. 2.
4.3.3 Control Stick Tension Adjustment
The stick gimbal tension is fully adjustable for each axis. This allows
you to fully customize your
radio‘s control feel. Simply
adjust each gimbal‘s spring to
your desired tension.
1. Switch off the transmitter
and remove the 7 screws
t h a t
s e c u r e
the radio back cover. Next,
remove the radio back
cover.
Be sure to disconnect
the transmitter battery
pack connector.
1
2
3
4
17