Duplex Jeti DS-12, Manual

Page: 97 / 151

computer radio control system EN
• Cycling – if you wish a cyclic behaviour for your beacons,
turrets or radar assemblies just check this option.
• Always finish sequence – After checking this option, the
sequencer will never be interrupted and always will travel from the
beginning to the end of its path.
• The button clears all data from the sequencer and „ F3 Clr ”
resets it to the default state.
4.
4.
9.3.7 Accelerometer
The DS is equipped with an inertial unit that allows you to precisely
determine the orientation of the device in space. This unit consists of
a 3-axis gyroscope, 3-axis accelerometer and additional mathematic
operations. You can freely use this inertial unit to control any
function, trigger any voice announcements or you can simply flip
pages on the main screen.
You can configure some of the
i n e r t i a l u n i t p a ra m e te r s i n
A d v a n c e d P r o p e r t i e s - >
Accelerometer
. In the picture , a)
the actual orientation of the
transmitter is displayed. The axes
GX, GY, GZ are defined as roll, pitch
and yaw in the same order. The
graph shows the final values after
all corrections have been made.
a)
Within this menu, you can edit
following parameters:
Filtering – This increases
smoothness of the movement for
each axis separately. You can set
values in range from 0 to 10. Zero
value means no filtering and gives
fast reactions. The higher the
filtering setting, the movement
becomes slower and smoother.
Sensitivity – This influences
the gain of the inertial unit for each
axis separately. If you feel that the
reactions of the controlled
function are too small for the
particular movement, you can
simply increase the corresponding
value of sensitivity, numerically up
to 400%.
c)
b)
Dead Zone – This means that as the value is increased, the more
you can move the transmitter around the middle position and the
output of the inertial unit will remain zero.
Pitch Offset - This shifts the GY axis so that you don’t have to hold
or keep the transmitter in a completely horizontal position all the
time.
You can also view the raw data coming from accelerometer and
gyroscope by pressing the
„ F1 button ” (see picture ) . This might b )
help you to fine tune your setup.
(*depends on equipment)
97