DSEGenset DSEA108, Operator'S Manual

Page: 54 / 58

CAN Interface Specification
057-281 ISSUE: 1 Page 54 of 58
Data Addresses Continued.
R/W: Read/Write
R: Read Only
Index Description Range Type Scaling and units
59 Output limit overshoot 0 to 300 R/W 1 %
60 Output limit overshoot delay 0 to 100 R/W 0.1 s
61 Soft Start Ramp Start Point (%) 100 to 900 R/W 0.1 %
62 Soft Start Ramp Rate (% / Hz) 50 to 1000 R/W 0.1 %/Hz
63 Start-up Fail Delay 10 to 100 R/W 0.1 s
64 Loss of Feedback Delay 1 to 100 R/W 0.1 s
65 Over Excite Trip 100 to 1500 R/W 0.1 V
66 Over Excite Delay 1 to 50 R/W 0.1 s
67 External Potentiometer OC Alarm Enable 0 / 1 R/W 0: Disabled
1: Enabled
66-199 Reserved
200 Generator Frequency R 0.1 Hz
201 Generator Voltage R 0.1 V
202 Droop Current R 0.001 A
203 Excitation Voltage R 0.1 V
204 Auxiliary Voltage R 0.1 V
205 External Potentiometer R Ohms
206 External Voltage R 0.01 V
207 Status Flags R See Status Flag List
208 DIP Switch Positions R See DIP Switch Position List
209 Software Version R Byte3: 0
Byte2: Major Version
Byte1: Minor Version
Byte0: Build Nuber
210 Bootloader Version R Byte3: 0
Byte2: Major Version
Byte1: Minor Version
Byte0: Build
300 Number of stability selections R
301 Number of alternative selections R
302 Maximum Excitation Output Offset R 0.1 %
303 Soft Start Ramp Start Point Minimum R 0.1 %
304 Soft Start Ramp Start Point Maximum R 0.1 %
305 Soft Start Ramp Rate Point Minimum R 0.1 %/Hz
306 Soft Start Ramp Rate Point Maximum R 0.1 %/Hz
307 Droop Maximum R 0.1 %
8.2.4.1 STATUS FLAG LIST
Status Flags (Address 207) are described as follows:
Bits Description
0 & 1 Configuration File Lost
2 & 3 Start-up Fail Trip
4 & 5 Over Excite Trip
6 & 7 Loss of Feedback Trip
8 & 9 Under Frequency Trip
10 & 11 Potentiometer Fault
12 & 13 UFRO Active
14 & 15 Integral Limit Active
16 & 17 Current Limit Reached
18 to 31 Not Used (all bits set to 1)
Where the status is shown by the following bit patterns:
Value (binary) Meaning
00 Off
01 On
10 Error (Not Used)
11 Unimplemented