USER MANUAL
CAMERAS IP H.264 1080P FULLHD
Page:
17
Page:
17
DSE SRL - ITALY - WWW.DSE.EU
Network Configuration
After providing power to the camera via a 12VDC power supply or via POE and after connecting the network you are necessary to
proceed to the configuration of the network parameters in order to be able to make the cameras are accessible from the PC on the
network. The cameras are supplied with
address 192.168.0.120 Factory
network. The cameras are supplied with
address 192.168.0.120 Factory
SOFTWARE IPSEARCH
The CD supplied with the camera software is included
IPSEARCH
that requires no installation and can easily be run on any PC on
The CD supplied with the camera software is included
IPSEARCH
that requires no installation and can easily be run on any PC on
The CD supplied with the camera software is included
IPSEARCH
that requires no installation and can easily be run on any PC on
the network. The function of this software is to detect the presence of the camera network regardless of its address and allow you
to configure the network address of the camera so as to be consistent with your network. We recall that because the camera is
visible from the other PCs on the network it is necessary that the first 3 address parts are the same as other network PC and is
equal also the subnet mask. And 'advisable to connect a network camera at a time, and insert new ones after you have set earlier.
PRELIMINARY CHECKS
Before you must obtain from your network some information about the management of the IP addresses used on your network. E
'need to know an IP address can be assigned to the camera that is not equal to any other device already present in the network. If
you are unsure about your network's operation you can use certain commands in DOS PROMPT
On a network PC launched a DOS window available between the Windows accessory programs. Type IPCONFIG at the
command prompt and press ENTER. They will see the TCP / IP parameters. The second line is the IP address assigned to your
computer.