Drayton Wiser, User Manual

Page: 35 / 57

35/57
Wiser Heat Hub
R
Operate
What do the buttons do? Getting to know the Heat Hub
R
The Heat Hub
R
is the central control unit of
the Wiser system. All incoming requests from
heating devices (“Boost the temperature in the
Living Room”) are processed by the Heat Hub
R
.
It also switches the boiler ON when required.
The Heat Hub
R
is available in three variants and
depends on your heating system.
•
Heat Hub
R
One Channel
1x Heating -> for combi boilers
• Heat Hub
R
Two Channel
1x Heating and 1x Hot Water -> for
conventional boilers with a separate hot water
cylinder
• Heat Hub
R
Three Channel
2x Heating and 1x Hot Water -> for large
properties with dual heating circuits
Reset the Heat Hub
R
Have a look at: Removing devices and factory
reset -> page 49
Set-up button
Within the initial installation
of the system, enter set-up
Mode and activate the
temporary Wi-Fi network.
Hot water override button
To turn ON the Hot Water
for 1 hour, press and hold
the button for >3 s.
To turn OFF the override,
press the Hot Water button
again.
Heating override button
To turn ON all heating for
2 hours, press and hold the
button for > 3 s.
To turn OFF the override,
press the Heating button
again.
Note: While this switch
turns ON or OFF the boiler,
it does not open or close
any radiator thermostats.
The override states for the Heating and Hot Water buttons are not shown in the Wiser Heat app .
These act as a fall-back state in the event that other controls are unavailable.