22
Installation instructions
|
Dräger Interlock
®
5x00/7x00
|
Installation
4 Installation
4.1
Requirements for installation
WARNING
Danger!
Alterations and additions to the device may cause danger.
Such alterations and additions invalidate the certificate of installation contained
in the instructions for use.
►
There may be no alterations or additions made to the device.
NOTICE
Install the device only for interruption and connection to the starter relay control
line.
●
The Dräger Interlock 5x00/7x00
1)
is intended for installation into motorised
vehicles. These can have a power supply voltage of 12–24 V.
●
Prior to installing the handset, please decide upon a suitable mounting
location and method together with the owner of the vehicle.
●
If the stand-by current consumption (see "Technical data", page 31) is too
high for the particular vehicle, use a vehicle battery with a higher capacity.
●
The instrument is not a substitute for a vehicle immobilizer for theft
protection.
●
Install the control box in line with vehicle-specific stipulations.
4.2 Installation
mode
CAUTION
The device is supplied in an installation mode, depending on configuration. In
this mode, the device immobilizer is not yet enabled. The vehicle's engine can
be started after the unit is installed without a breath sample being given.
Deactivate the installation mode to put the device into operation.
4.3 Installation
of
components
●
To begin the installation process, install all components temporarily at their
intended positions.
●
Ensure the suitability of the mounting locations and that the installation does
not obstruct normal use of the vehicle.
●
Ensure that the safety of passengers is not impaired.
●
Choose mounting position where sufficient protection against water, dust
and high temperatures is ensured.
4.3.1 Control
unit
NOTICE
Only install the device permanently following consultation with the owner of the
vehicle.
When installing the control unit, ensure that the connection cable for the
handset is secured against tensile load (e.g., using a cable tie).
●
Install control unit in as hidden a position as possible, such as under the
seat or front dash on the steering column. Fix with cable ties.
4.3.2 Handset
WARNING
Do not install holster for the handset in front of air-bags.
●
Decide upon mounting location for the holster for the handset ensuring
minimal obstruction by the handset and easy accessibility for the driver.
●
If the cable from the control unit to the handset is too tightly stretched or too
short, re-position the handset, the control unit or both.
4.4 Connecting
the
leads
Check for any installation instructions specific to the vehicle, and if these
exist, continue by following those instructions. A list of available installation
instructions can be obtained from Dräger.
1)
Interlock is a registered trademark of Dräger.
AIRBAG
