DP Megacontrol Series, Installation And Operating Instructions Manual

Page: 16 / 72

16
The selected pump will run for a period of 10 seconds
and stops. The pump operation mode is changed to
Disabled (off) This is to avoid that the pump runs
unprotected.
8.2.1 Putting the pump into automatic
operation again
The pump has to be put in operation again by
selecting the
Automatic mode .
8.3 Retrieve and reset a fault
Information about faults can be retrieved by pressing
the 'diagnosis' hot key
Stay in the selected parameter 1-2-1 Opera-
tion mode and press OK.
Select the pump number again by pressing
the navigation keys.
To confirm the selection, press OK.
Select the operation mode Automatic .
To confirm the selection, press OK.
Example: Parameter 2-1-1 Current messages
Press the diagnosis key. 2-1 General
appears in the display.
Press the OK key. 2-1-1 Current messages
appears in the display.
Press the OK key again. The list with the
current faults or the message 'no faults'
appears in the display.
When there is a fault that has a circle with a dot in it, the
fault is still active
No Water
When there is a fault that has an open circle, the fault is not
active, but has not been acknowledged yet.
No Water
When there is a fault that has a circle with a dot in it and a
check mark following the fault message, the fault is still
active and the fault has been acknowledged as well. When
the fault is remedied now, it will be reset immediately.
Example: Parameter 2-1-2 History
Press the diagnosis key. 2-1 General
appears in the display.
Press the OK key. The display then shows
2-1-1 Current messages;
2-1-2 History.
You can select History by pressing the navi-
gation key.
Press the OK key. The list of faults from the
past appears.
You can select the fault by pressing the nav-
igation key.
Press the OK key. The below listed informa-
tion becomes visible.
The following information about the fault is known:
•
Date and time of occurrence of the fault
•
Date and time of acknowledgement of the fault
•
Date and time of remedy of the fault