Doosan G10WMI-2D-T2, Installation, Operation & Maintenance Manual

Page: 60 / 106

Operation & Maintenance Manual Operating Instructions
60 22637300
Min Stability Time
Generator nominal voltage starts being detected after starter is switched off, idle time elapses,
and this time has elapsed.
Max Stability Time
If generator nominal voltage is not stable within the time after starter is OFF and idle time
elapes, then the genset will shutdown. Stability means that voltage and frequency are within
warning setting limits.
Cooling Speed
This function is not used. Reserved for future applications. Factory default setting = NOMINAL.
Cooling Time
Runtime of the unloaded generator set to cool the engine before stop.
After Cool Time
This function is not used. Factory default setting = 0.
Stop Time
When genset stop sequence is initiated, fuel solenoid output cannot activate during this time.
Fuel Solenoid
Determines behavior of the Binary output FUEL SOLENOID.
DIESEL: Output closes together with Binary output STARTER.
The output opens if Emergency stop comes or Cooled generator set is stopped or in pause
between repeated starts.
GAS: Output closes together with Binary output IGNITION if RPM is over the 30 RPM (Fix
value). Output opens after stop command or in pause between repeated start.
Fuel Pull Coil
Time duration that output Fuel Pull Coil is active. This output is used for momentary activation
of a fuel solenoid pull coil.