Doosan G10WMI-2D-T2, Installation, Operation & Maintenance Manual

Page: 58 / 106

Operation & Maintenance Manual Operating Instructions
58 22637300
SETPOINTS DESCRIPTIONS
BASIC SETTINGS
Gen-Set Name
User defined name, used for the CONTROLLER identification at remote phone or mobile
connection. The Gen-set name is max 14 characters long and has to be entered using Lite
Edit software.
Nomin Power (3ph)
Nominal power of the generator in three phase HI-WYE series connection.
Nomin Current
Nominal current of the generator in three phase LOW-WYE parallel connection.
CT Ratio
The generator set current transformer ratio.
PT Ratio
The generator set potential transformers ratio. PT's are not needed on 480 Volt systems and
below.
Nominal Voltage 1
Line to neutral voltage in LOW-WYE, Parallel connection.
Nominal Voltage 2
Line to neutral voltage in HI-WYE, series connection.
Gear Teeth
Number of teeth on the engine gear for the pick-up. Set to zero, if no pick-up is used. Engine
speed is counted from the generator frequency. Electronic engines get the speed signal from
the engine controller.
Alternator Frequency
Frequency of the battery alternator when the controller stops cranking.
Nominal RPM
The nominal engine speed of the generator set.
Mode [OFF, MAN, AUT]
This is the equivalent of controller "Mode" buttons.
Fault Reset Go to Manual
Enables or Disables return to MAN mode when reset is pushed.
Display Backlight Timeout
The time limit in minutes for the backlight to go off.