Doosan G10WMI-2D-T2, Installation, Operation & Maintenance Manual

Page: 6 / 106

Operation & Maintenance Manual Drawbar Notice
6 22637300
Drawbar Notice
This machine may have been shipped from the factory with the drawbar positioned upright. To
convert from shipping position to towing position, the following tools are required:
Tool Required:
Ratchet, 24mm socket and an 18mm socket to fit ratchet
Torque wrench set to 166 ft-lbs (226 Nm) and 67 ft-lbs. (91 Nm)
24mm socket and an 18mm socket to fit torque wrench
Hardware included: (1) 16mm nut, (2) Washers, (2) Safety Chains
1. Remove hardware box from generator.
2. Open box and remove the bag containing hardware, safety chains and assembly
instructions.
3. Using the jack, raise the front of the unit so that the end of the drawbar is
approximately 1 inch above the ground.
4. While holding the drawbar, carefully remove the temporary retaining bolt that holds
the drawbar to the top of the enclosure (See Fig. 1).
5. Carefully lower drawbar to the Level Position.
6. Install the bolt (that was removed in Step 4) with the washers and nut from the
included hardware to secure the end of the drawbar underneath the unit and torque to
166 ft-lbs (226 Nm). Also torque the drawbar pivot bolt to 166 ft-lbs. (226 Nm). See
Figure 2).
7. Install safety chains by first removing the longest bolt used to attach the hitch then
insert the last link of one chain onto the bolt. Slide one spacer back on the bolt and put
the assembly back into the hitch. Slide the other spacer onto the bolt, then the last link
of the other safety chain washer. Tighten the nut to 67 ft-lbs (91 Nm).