DUAL CLIMA
18
Consult with the user before choosing the location of the device. It should not be placed next to
sensitive walls, such as on the wall next to a bedroom. Make sure that the location of the heat pump
is not disruptive to neighbours (sound level, air currents generated, low temperature of the air
blown with risk of freezing plants in the path, etc.).
Choose a location that preferably has sunlight and is
protected from strong and cold winds. If the heat pump is
exposed to gusts of wind that make it possible to overturn it, it
should be supported by suitable guys, as indicated in the
figure.
The device must be sufficiently accessible for subsequent installation and maintenance work. Make
sure that the passage of the hydraulic and electrical connections to the interior of the house is
possible and comfortable. The spacing measures indicated in the figure above are those strictly
necessary to ensure correct operation of the device; however, sometimes, it will be essential to
provide more space for maintenance work.
The
DUAL CLIMA
heat pump is a device specially designed for outdoor installation. Nevertheless,
avoid installing it in a place where it may be exposed to significant water stains or spills (e.g. under
a faulty gutter, near gas outlets, etc.). Move the appliance away from heat sources and flammable
products.
In areas where abundant and copious snowfalls occur, special care must be taken to protect the
heat pump from possible obstructions due to accumulation of snow around it. The obstruction of
the air inlet and/or outlet of the machine due to the accumulation of snow may cause malfunction
of the unit and possible breakdowns. The heat pump must be raised at least 100 millimetres above
the maximum expected snow level. In turn, the roof should be protected from accumulation of
snow, by means of a roof projecting from the building or a similar structure.
9.2
Accessories Supplied
The following accessories are supplied in the interior of the
DUAL CLIMA
heat pump. Before
proceeding with the installation of the machine, make sure that you receive them and that they are
in good condition.
Documentation:
Inside the machine, open the front door to find the
documentation bag, where all the manuals and documents necessary for the
use and installation of the heat pump are included.
Main board:
It is supplied inside the machine and can be found by removing
the cover of the electronic boards. Before connecting the power supply to the
machine, the control panel should be installed inside the house.
Drain valve:
It is supplied inside the machine, tied with a flange to one leg of
the compressor. This key must be installed in the drain socket on the back of
the heat pump before filling the water in the heating/cooling circuit (see
"Diagrams and Measurements"
).
4x Anti-vibration dampers:
Four units are supplied in a bag stuck on the back
of the machine, next to the hydraulic outlets.
Summary of Contents for DUAL CLIMA 11
