13
7
CLOCK AND TIMER SETTINGS
The
DUAL CLIMA
heat pump integrates a time and date display, through which some functions are
managed. It is thus essential to set the correct date and time when commissioning the heat pump. In
addition, this clock can be used to set the periods for turning on and off the desired operating modes
for each day of the week (weekly programming).
7.1
Time and day settings
To set the time and day of the week, press
and the day of the week symbol will flash. Use
buttons
to select the day of the week and press
to confirm. Next, the hour digits will flash.
Use buttons
to select the hour and press
to confirm. Finally, the minute digits will flash.
Use buttons
to select the minutes and press
to confirm the selected value. The time
setting mode will close automatically.
7.2
Timer Settings
The
DUAL CLIMA
heat pump has a weekly timer function, through which the on and off periods
can be set, as well as the desired operating modes in each of them. In one day, 3 points can be set
for the activation (mode selection) and 3 points for the total shutdown of the pump. Points
1
,
3
and
5
enable the desired operating mode. Points
2
,
4
and
6
disable all operating modes that were
active at the programmed time.
The start and shutdown points may be adjusted independently from each other, i.e. it is not
necessary to adjust them in pairs (1 with 2, 3 with 4, etc.). Only the start points (1, 3 and 5) can be
adjusted in such a way that they change the operating mode each time the programmed time is
reached for each of them (e.g. point 1: 06:00h
+
, point 3: 21:00h
, daytime activation in
Heating mode, keeping the DHW service active for 24 hours).
When the programmer is set, the programming symbol will appear permanently enabled (
) on
the electronic controller screen, indicating that time programming is enabled. To restore the
manual operation and erase all settings of the time programmer, simultaneously press and holding
buttons
+
for 3 seconds. The programming symbol (
) will be disabled on the screen.
To access the setting mode of the time programmer press and hold the
button for 3 seconds.
The symbol
will flash on the screen, as well as the and the start point
1
for said day.
Summary of Contents for DUAL CLIMA 11
