19
TROUBLESHOOTING
–
Before making a request for repairs, check a trouble for yourself. If any abnormality is found, control your machine according to the
description of this manual. Never tamper or dismount any part contrary to the description. For repairs, contact Authorized Service Agent or
local dealership.
State of abnormality
Probable cause (malfunction)
Remedy
Failure to operate primer pump
Push 7 to 10 times.
Low pulling speed of starter rope
Pull strongly.
Lack of fuel
Feed fuel.
Clogged fuel filter
Clean
Broken fuel tube
Straighten fuel tube
Deteriorated fuel
Deteriorated fuel makes starting more difficult.
Replace with new one. (Recommended
replacement: 1 month)
Excessive suction of fuel
Set throttle lever from medium speed to high
speed, and pull starter handle until engine
starts.
If engine will not start still, remove spark plug,
make electrode dry, and reassemble them as
they originally are. Then, start as specified.
Detached plug cap
Attach securely
Contaminated spark plug
Clean
Abnormal clearance of spark plug
Adjust clearance
Other abnormality of spark plug
Replace
Abnormal carburetor
Make request for inspection and maintenance.
Starter rope cannot be pulled
Make request for inspection and maintenance
Engine does not start
Abnormal drive system
Make request for inspection and maintenance
Insufficient warm-up
Perform warm-up operation
Choke lever is set to “CLOSE” although engine
is warmed up
Set to “OPEN”
Clogged fuel filter
Clean
Contaminated or clogged air cleaner
Clean
Abnormal carburetor
Make request for inspection and maintenance
Abnormal drive system
Make request for inspection and maintenance
Detached throttle wire
Attach securely
Engine stops soon
Engine speed does not increase
Detached connector
Attach securely
Abnormal electric system
Make request for inspection and maintenance.
Engine does not stop.
When the engine does not start after warm-up operation:
If there is no abnormality found for the check items, open the throttle by about 1/3 and start the engine.
Run engine at idling, and set choke
lever to CLOSE.
