Dodge Challenger SRT 392 2015, Operating Information Manual

Page: 53 / 658

What is the weight limit (child’s weight of the child
restraint) for using the Tether Anchor with the seat belt to attach a
forward facing child restraint? Weight limit
of the Child
Restraint
Always use the tether anchor when using the seat belt to install
a forward facing child restraint, up to the recommended weight
limit of the child restraint.
Can the rear-facing child restraint touch the back of the front
passenger seat?
Yes Contact between the front passenger seat and the child re-
straint is allowed, if the child restraint manufacturer also allows
contact.
Can the head restraints be removed? Yes Center Only may be removed
Can the buckle stalk be twisted to tighten the seat belt against
the belt path of the child restraint?
No Do not twist the buckle stalk in a seating position with an ALR
retractor.
Installing A Child Restraint With A
Switchable Automatic Locking Retractor
(ALR)
1. Place the child seat in the center of the
seating position. For some second row
seats, you may need to recline the seat
and/or raise the head restraint to get a better
fit. If the rear seat can be moved forward and
rearward in the vehicle, you may wish to
move it to its rear-most position to make
room for the child seat. You may also move
the front seat forward to allow more room for
the child seat.
2. Pull enough of the seat belt webbing from
the retractor to pass it through the seat belt
path of the child restraint. Do not twist the
belt webbing in the seat belt path.
3. Slide the latch plate into the buckle until you
hear a “click”.
4. Pull on the webbing to make the lap portion
tight against the child seat.
5. To lock the seat belt, pull down on the
shoulder part of the seat belt until you have
pulled all the seat belt webbing out of the
retractor. Then, allow the webbing to retract
back into the retractor. As the webbing re-
tracts, you will hear a clicking sound. This
means the seat belt is now in the Automatic
Locking mode.
6. Try to pull the webbing out of the retractor. If
it is locked, you should not be able to pull out
any webbing. If the retractor is not locked,
repeat step 5.
7. Finally, pull up on any excess webbing to
tighten the lap portion around the child re-
straint while you push the child restraint
rearward and downward into the vehicle
seat.
50