Dodge Challenger SRT 392 2015, Operating Information Manual

Page: 131 / 658

Diagnostics — If Equipped
Push and release the UP or DOWN arrow
button until the diagnostic Menu where the
Driver is able to view certain vehicle faults.
•
Push OK to have the 1st code in the stack
sent
•
There is a delay when the next diagnostic
code is requested during which the following
message is displayed:
“Checking System for Diagnostic Codes”
•
Driver must push the OK button again to see
the next Pcode otherwise current message
remains displayed.
•
Driver exits when they cycle to another sub-
menu (up or down).
•
Faults are displayed from oldest to the
newest.
•
If the menu is exited before the end of codes
is reached - when the driver re-enters the list
will be restarted from the beginning.
•
When no codes are present or the last code
is reached = (P000) and this message is
displayed:
“No Further or End of Diagnostic Codes”
Uconnect® SETTINGS
The Uconnect® system uses a combination of
buttons on the touchscreen and buttons on the
faceplate located on the center of the instru-
ment panel that allows you to access and
change the customer programmable features.
Buttons On The Faceplate
Buttons on the faceplate are located below the
Uconnect® system in the center of the instru-
ment panel. In addition, there is a Scroll/Enter
control knob located on the right side. Turn the
control knob to scroll through menus and
change settings (i.e., 30, 60, 90), push the
center of the control knob one or more times to
select or change a setting (i.e., ON, OFF).
Your Uconnect® system may also have a
Screen Off and Back buttons on the faceplate.
Uconnect® 8.4 Buttons
1 — Uconnect® Main Menu Buttons On The
Touchscreen
128