Dodge Challenger SRT 392 2015, Operating Information Manual

Page: 179 / 658

CAUTION!
Damage to the transmission may occur if the
following precautions are not observed:
•
Do not shift from REVERSE, PARK, or
NEUTRAL into any forward gear when the
engine is above idle speed.
•
Shift into PARK only after the vehicle has
come to a complete stop.
•
Shift into or out of REVERSE only after the
vehicle has come to a complete stop and
the engine is at idle speed.
•
Before shifting into any gear, make sure
your foot is firmly on the brake pedal.
Using Fob With Integrated Key (Tip Start)
NOTE:
Normal starting of either a cold or a warm
engine is obtained without pumping or
pressing the accelerator pedal.
Do not press the accelerator. Use the Fob with
Integrated Key to briefly place the ignition in the
START position and release it as soon as the
starter engages. The starter motor will continue
to run, and it will disengage automatically when
the engine is running. If the engine fails to start,
the starter will disengage automatically in 10
seconds. If this occurs, place the ignition in the
LOCK/OFF position, wait 10 to 15 seconds,
then repeat the “Normal Starting” procedure.
Keyless Enter-N-Go™
This feature allows the
driver to operate the ig-
nition switch with the
push of a button, as long
as the ENGINE START/
STOP button is installed
and the Remote Start/
Keyless
Enter-N-Go™
Key Fob is in the pas-
senger compartment.
Normal Starting
Using The ENGINE START/STOP Button —
Automatic Transmission Only
1. The transmission must be in PARK or NEU-
TRAL.
2. Press and hold the brake pedal while press-
ing the ENGINE START/STOP button once.
3. The system takes over and attempts to start
the vehicle. If the vehicle fails to start, the
starter will disengage automatically after 10
seconds.
4. If you wish to stop the cranking of the engine
prior to the engine starting, press the button
again.
NOTE:
Normal starting of either a cold or a warm
engine is obtained without pumping or
pressing the accelerator pedal.
Using The ENGINE START/STOP Button —
Manual Transmission Only
1. Press and hold the clutch pedal while press-
ing and holding the ENGINE START/STOP
button.
2. Release the button when the engine starts. If
the vehicle fails to start within 15 seconds,
release the button, wait 10 to 15 seconds,
then repeat the “Normal Starting” procedure.
176