Docomo FOMA D702iF, Manuals

Page: 425 / 451

4
FOMA terminal can be connected using a desktop
holder (optional) during the charging. However,
charging time becomes longer.
a
Connect the desktop holder to the AC
adapter
･
Plug the AC adapter into the wall outlet.
b
Connect FOMA terminal and FOMA USB
cable
c
Along with the desktop holder, insert FOMA
terminal at an angle as shown in the figure
･
Check that the sub-display lights in red.
INFORMATION
● FOMA terminal can be connected by using a data
communication adapter D01(optional) while
charging. However, charging time becomes longer.
● Do not remove the FOMA USB cable during data
communication, or give shock to FOMA terminal and
desktop holder. It may cause the interruption of
charging or data communication, malfunction or
failure of PC or FOMA terminal, or loss of data.
● Starting to charge during data communication may
not complete charging. To complete charging, it is
recommended that you end the data communication
first, and then start charging.
Installation of the communication
configuration file (driver)
Installing the communication configuration file
Before operation, read “Before installation/
uninstallation”
☛
P3
･
Perform Steps 1 to 3 first, and then connect
FOMA terminal to a PC.
For Windows XP
1 Insert the attached CD-ROM into a PC
2 Click スタート (Start) and ファイル名を
指定して実行 (Run)
z
Enter “<CD-ROM
drive letter>: ￥ USBDRIVE ￥ D702iF.exe” in
名前
(Name)
z
Click
OK
3
Click
インストール開始
(Start
installation)
A screen requesting to connect FOMA D702iF to
the PC appears.
4 Connect FOMA terminal to the PC
Installing is started and completed, then the
message appears.
･
Connect FOMA terminal while the power is on.
5 Click
OK
･
Go to “Checking the communication
configuration file”, and check the name of the
device installed.
INFORMATION
●
Installation may take a few minutes.
●
When Windows rebooting is prompted on the screen,
follow the instruction and reboot.
●
If a PC and FOMA terminal are connected before
the communication configuration file is installed,
another driver may be automatically installed. When
this happens, performing the operation in Step 2
displays a message saying that the installed driver
must be uninstalled. Uninstall the driver following
instruction shown on the display and install the
communication configuration file.
Connecting while charging
Desktop holder
FOMA USB cable connector
for FOMA terminal
(label facing up)
AC adapter connector
( facing down)
Example
D702iF Manual for Data Commu.fm 4 ページ ２００６年７月２９日 土曜日 午後１２時１分