5.3 Manual Gate Operation
This operator is equipped with a manual release system that will allow the gate to be pushed open in the event of a power
outage or equipment failure.
NEVER
remove the hub from the operator after manually releasing it.
NOTE: DoorKing operators have a built-in alarm reset push button mounted on
the operator above the power ON-OFF switch. Activating this button will return
the gate operator to normal operation,
but will not activate the gate operator.
When the operator is in a hard shutdown condition (audio alarm activated or audio alarm “chirps” every 5 seconds),
to silence the alarm, press the alarm reset button.
Once the gate has been reset, an open or close command is needed to start the gate
operator. Most activating commands will cause the gate operator to cycle to the
open position. This includes activation of a key switch or open command and
activation of the automatic exit loop. Activation of a close command will run the gate
to the closed position.
•
Before resetting a hard shutdown, determine why the shutdown occurred.
Inspect the gate for any obstructions along its path that could have activated
the inherent entrapment sensing system. Inspect the gate and gate hardware.
1. During normal powered operation,
emergency vehicles access the gate by use of the
Emergency Vehicle
Access Device
installed on your gate system. The type of device that is used in your community is dependent
on your city codes. These devices may include (but are not limited to) Fire Department lock boxes, Click-2-
Enter radio receivers, strobe light sensors, siren sensors, etc.
2. In the event of a power failure,
The gate operator is equipped with a built-in
Battery Back-Up System
,
this system will allow the gate operator to continue to function normally when primary (AC) power is
removed.
3. In the event of a primary (AC) power failure and a back-up system (DC) power failure
(low charged or
dead batteries for example), the system must have a release system to allow the gate to be
Manually
Operated
(See next page).
Resetting a Hard Shutdown
The automatic vehicular gate system must be designed to allow access to emergency vehicles under different operating
conditions.
Emergency Vehicle Access Conditions
Never attempt to manually push open any gate with an operator attached
to it until you have verified that ALL power to the operator has been shut-off.
This gate operator CAN NOT be manually forced open in the event of a
power failure without FIRST manually releasing the gate!
(See next page)
DC
POWER
AC
POWER
ALARM
RESET
ON
OFF
OFF
ON
Alarm
Reset
Button
6524-065-R-12-17
31
