DKS 1838 Access Plus, Installation & Owner'S Manual

Page: 18 / 40

1838-066-E-12-16 14
Internet
1
2
3
4
There are a number of ways to communicate with the 1838 via a network connection. Before any programming can be
attempted, you need to install the Access Plus programming software on the computer you want to use for this purpose. The
computer must have a network card installed. Follow the instructions in the Access Plus programming software help guide and
refer to section 2.3 for setup information.
Using a network connection, you can connect to the 1838 in different ways:
Locally with a direct connection from the computer to the 1838 using a commercially available crossover cable.
1.9.2 Network Connections
Direct Connection Using a Crossover Cable
MO
DEM
/ TCP
ENB
1972-010
SW
1
1
2
3
4
5
6
7
8
BAD
DN
S LAN
DO
WN
RS
-485
RX
J4
ON
J1
RJ
-45
Jack
(Cat5)
SW
2
ON
SOFTW
ARE
INST
ALLED
SOFTW
ARE
INST
ALLED
Maximum distance on
Cat5 wire run is limited
to 325 feet (100 meters).
Maximum distance on Cat5 wire
run (Crossover cable) is limited
to 325 feet (100 meters).
Note: Router address is set to 192.168.001.001
(See 2.3.3 Set the gateway (router) IP address).
Note: 1838 address is
set to 192.168.001.030
(See 2.3.1 Set the 1838
IP address).
Note: Notebook OR PC address is set to 192.168.001.107
(Notebook OR PC searches for 192.168.001.030 in LAN network).
RJ-45
RJ-45
RJ-45
RJ-45
Wired or Wireless Router
(Wireless shown)
RJ-45
Cable
(Cat5)
RJ-45
Cable
(Cat5)
Locally by connecting the computer to the 1838 through a router. This is a Local Area Network (LAN) connection.
Direct Connection Using a Router (LAN)
MO
DEM
/ TCP
EN
B
1972-010
SW
1
1
2
3
4
5
6
7
8
BAD
DN
S LA
N
DO
WN
RS
-485
RX
J4
ON
J1
RJ
-45
Jack
(Cat5)
SW
1
ON
Cat5
Cat5 for LAN Connection
Wired to a PC
for LAN Connection
Wireless
When us
ing
a
Wireless Router
SOFTW
ARE
INST
ALLED