1838-066-E-12-16
6
Sur
face
Knock-Out
Conduit
Enclosure
Note:
Enclosure door not
shown in illustration to better
clarify mounting holes.
Use appropriate hardware to
secure enclosure to the
surface (not supplied).
1.2 Install Enclosure
1.
Mount the enclosure using the mounting holes provided in the corners (see section 1.3 for dimensions). Be sure that
mounting screws (Not supplied) do not protrude into the enclosure where they could cause a short on the back of the circuit
board. Make any necessary conduit connections through the bottom of the enclosure using the existing conduit knock-outs.
DO NOT
make any new conduit holes in the enclosure.
2.
Route all wiring through conduit into enclosure.
3.
Clean out the enclosure. Make sure that all dirt, metal and/or wood debris is removed.
4.
Re-install circuit board back into the enclosure (Reverse section 1.1 steps). Use the wiring schematics in the back of this
manual to help re-install the circuit board if necessary.
DO NOT
apply any power at this time.
Summary of Contents for 1838 Access Plus
Page 39: ...1838 066 E 12 16 35...
