DK-Technologies PT5300, Manual To Installation And Operation

Page: 36 / 90

30 | PT5300
Operation:
• Use the
and buttons to select mode, hours or minutes.
• Use the
and buttons to find the mode you want.
• Use the
and buttons to specify the time at which re-sync shall occur.
• When the desired system appears in the display, press OK to confirm. Otherwise move the cursor to ESC and
press to cancel.
To change time and date settings, select TIME
2NDMNU: ../LTC A/TIME, select
2NDMNU: <TIMEZONE> DAYLIGHT ESC
In the TIME menu, the clock and date, as well as daylight saving parameters, can be setup.
Operation:
• Use the and buttons to select the time setting you want alter, then press
• TIMEZONE and DAYLIGHT will open a new menu.
Leaving the function takes you back to the LTC submenu.
To change time zone, select TIMEZONE
2NDMNU:../LTC A/TIMEZONE, edit
TIMEZONE: +01:00 OK ESC
In the TIMEZONE menu, you can set the time zone, by offsetting the UTC time in steps of 30 minutes.
Operation:
• Use the and buttons to select either hours or minutes.
• Use the
and buttons to set the desired offset.
• When the desired UTC offset appears in the display, move the cursor to OK and press E
•
Note: If you want the Timezone settings to take effect immediately go to the main LTC menu, and select < SYNC > to
reset the frame- counter. The Timezone correction may take up to 3 minutes to take effect.
To change daylight saving options, select DAYLIGHT
2NDMNU:../LTC/DAYLIGHT, select
MODE:<AUTO>DST: on START END OK ESC
In the DAYLIGHT menu, the daylight savings settings are made. There are three different modes, to choose from.
AUTO mode switches to, and back from daylight saving time automatically. This means the time advances one hour, at
the chosen start date, and resets at the end date. The PT5300 will notice you of this change. In CONFIRM mode, the
PT5300 does NOT change the time automatically, but will instead notice you and wait for confirmation to switch time. In
OFF mode, no daylight saving changes will be made. You can also immediately change the state, by setting DST
(daylight saving time) on or off in the menu.
Operation:
• Use the and
buttons to select desired parameter.