DJO Global 80.00.023, Operating Instructions Manual

Page: 83 / 276

79
Eng
lis
h
The ARTROMOT®-S3 device is subject to
particular precautions regarding elec-
tromagnetic compatibility (EMC). The
device must be installed and put into
service strictly in compliance with the EMC
directives set forth in the accompanying
documents.
Portable and mobile RF communication
systems may affect the ARTROMOT®-S3.
The ARTROMOT®-S3 should not be
used adjacent to or stacked with other
equipment. If adjacent or stacked use is
necessary, ARTROMOT®-S3 should be
observed to verify normal operation in the
configuration in which it will be used.
If you detect damage or malfunctions that
may impair the safety of the patient or
of the operator, have the device repaired
before using it.
If it is necessary to replace assemblies or
cables, only the manufacturer‘s original
parts must be used to ensure contin-
ued compliance with EMC requirements
after repair. This requirement applies to
the power supply unit, cables and cable
lengths, drive unit consisting of the motor
and the control system, the program-
ming unit incl. the coiled cable and the
connector.
The product designation ARTROMOT®-S3
used in the text below includes all product
variants.
Guidance and Manufacturer’s Declaration – Electromagnetic Emissions
ARTROMOT®-S3 is intended for use in the electromagnetic environment specified below.
It is the responsibility of the customer or user to ensure that the ARTROMOT®-S3 unit is
used in such an environment.
Emissions test Compliance Electromagnetic environment
– guidance
RF emissions to CISPR 11 Group 1 ARTROMOT®-S3 uses RF ener-
gy only for its internal function.
Therefore, its RF emissions are very
low and are not likely to cause any
interference in nearby electronic
equipment.
RF emissions to CISPR 11 Class B ARTROMOT®-S3 is suitable for use
in all establishments, including do-
mestic and those directly connected
to the public low-voltage power
supply network that supplies buil-
dings used for domestic purposes.
Harmonic emissions to
IEC 61000-3-2
complies with class
A requirements
Voltage fluctuations/flicker
emissions to IEC 61 000-3-3
complies
9.1 Electromagnetic emissions
9. IEC 60601-1-2:2007 and IEC 60601-1-11:2010