DJO Global 80.00.023, Operating Instructions Manual

Page: 80 / 276

76
The ARTROMOT®-S3 can be used on the
left and on the right shoulder joint. How-
ever, the device must be converted first.
This is done very quickly.
1. Activate the „transport setting“
function in the menu (see also
5.3) and start the ARTROMOT®-S3.
2. On both sides adjust an angle of 90°
for horizontal adduction/abduction
(indexing knob 12) (see conversion
drawing † ).
3. Open locking screw (14), remove the
armrest for the healthy arm and place
it on the seat (see conversion diagram
†
a).
4. Grasping the holding tube (17) of the
motion element, open locking screw
(14).
5. Remove the motion element and insert
it on the opposite side. Tighten locking
screw (14) (see conversion diagram †
b, c).
6. Open locking screw (20) and rotate the
forearm rest 180°.
Tighten locking screw (20) (see conver-
sion diagram
Œ
d).
7. Hold the forearm rest and open locking
screw (28).
8. Swivel the forearm rest to the other
side around motor B and tighten lock-
ing screw (28) (see conversion diagram
Å
e).
9. Insert the armrest for the healthy arm
into the holding tube and tighten lock-
ing screw (14).
10. Set horizontal adduction/abduction
to the desired value on the side of the
motion element (normally a value
between 0° and 40°, as needed).
Conversion diagram:
6.4 Conversion