DistyNotruf
pro
Ascom, operating instructions
The values for “threshold” and “time out” can be set through configuration.
The profile can be adapted to needs by varying parameters and timeout.
Timeout time can be set in this case, between 20 and 254 seconds.
The ‘man down’ variation will then be active in the basic setting.
It will be set to ‘motion detection’ by setting the checkbox.
If an event is triggered, i.e. an SMS transmitted / speech connection established, this will be
shown through a brief flashing of the red LED.
Performance characteristic is switched off in the CS.
Examples of setting the functions:
a) Function “Man Down”, Timeout = 240 seconds
Alarm time of 4 minutes must be set through configuration.
If the device is not moved for a minimum of 4 minutes, the respective SMS will be
displayed at the OAPT interface. The precise format is listed further behind (
MD
).
Alternatively, a call is put through to the preset number.
b) Function “Motion Detection”, Timeout = 180 seconds.
The function as well as the alarm time of 3 minutes must be set through configuration.
If the device has not been moved for 3 minutes and is then moved once again, an
SMS will be transmitted to the OAPT interface.
Alternatively, a call will be put through to the preset number.
Announcement tone off (ring tone, default: disabled)
When you get a call there is an audible indication in the form of a short "beep".
The locator options setting can be changed so that this sound is not heard.
Page 14 of 24
