DistyNotruf
pro
Ascom, operating instructions
Unsubscription
The logical disconnection of the
distyNotruf pro
and the DECT base station is done by
deleting the DECT subscriber in the base station. This process also includes the removal of
relevant data in the
distyNotruf pro
through the DECT protocol as long as the function is
supported by the base station.
Process: see “Factory setting”.
This is the last step required by the system administrator to delete the
subscription data of the
distyNotruf pro
from the system and thus
unsubscribe the device.
Subscription data are deleted also by resetting to the default status ( Factory
setting ).
After a maximum of 3 minutes, the
distyNotruf pro
switches to the sleeping
mode: no LED lights up, DECT activity is halted.
Factory setting
The following operating procedure is performed to reset to delivery status
factory setting (default), which will work only when the device is subscribed.
•
Set
distyNotruf pro
to CS. Red LED illuminates as confirmation and
acoustic “beep” signal is heard.
•
Press the alarm key latest after 5 seconds and hold for 10 seconds
•
Green LED illuminates
•
Let go of alarm key before LED switches off (2 seconds time)
•
A (450 Hz) tone is heard and red LED illuminates
•
Remove
distyNotruf pro
from charging cable
•
distyNotruf pro
switches to power down (every function switches off)
All values return to basic setting. The device is now ready for subscription again.
Characteristic
Factory setting
Personal setting
Emergency call
Not active
1
Ring tone volume
3
DECT radio activity
Not active
1 Stored number will not be erased during factory reset.
Page 8 of 24
