Dish Network DP512, User Manual

Page: 9 / 136

Chapter 1
Page 4
Introduction
Getting Started
After your system has been installed, order and watch your programming
using the following steps:
Step 1: Ordering Your Programming
1. Using a remote control, press SAT and then press the top
POWER button to turn on the receiver. Make sure the TV is
also on.
2. Press
GUIDE
.
You will see that some channels in the
Program Guide
appear
in white. These channels can be viewed immediately. However, many
channels will be in red. You cannot view these channels until you order
their programming.
3. Press the SYSTEM INFO button on the receiver front panel to display
the
System Info
screen.
Note
: The following screen is for example only. Be sure to use the
numbers on the
System Info
screen displayed on your own TV.
4. Call the Customer Service Center at 1-800-333-DISH (3474). A
customer service representative will help you start DISH Network
programming on your system and will discuss the various programming
packages available.
5. Choose a package and the representative will authorize your
programming.
6. Press
SELECT
to close the
System Info
screen.
7. Wait a few minutes and the channels you purchased will turn from red
to white, and can now be viewed.
Tip: The IR remote
control is used to
control TV1 menus
and programming
on a nearby TV. An
optional IR/UHF
Pro remote can be
used to control the
receiver from
another room.