Dish Network DP512, User Manual

Page: 31 / 136

Chapter 2
Page 26
Receiver Description and Installation
Confirming IR/UHF Pro Remote Control Operation
After any remote TV(s) have been connected to the receiver, do the following to
make sure an IR/UHF Pro remote can control the receiver from another room:
1. Press the SAT button to put the UHF Pro remote control in SAT mode to
control the satellite receiver.
2. From a remote TV, use the UHF Pro remote’s arrow keys to move around
the
Point Dish
screen. If you are able to move around in the
Point Dish
screen, you confirmed that the UHF Pro remote is controlling the receiver.
Programming the Recover Button for Your TV
Now the RECOVER button can be programmed to tune your TV back to the
channel (3 or 4) showing your satellite receiver’s programming.
1. Program your remote control to control your TV, using the instructions in
Control Other Devices with the Remote Controls on page 85.
2. Press and hold the TV mode button until all the other mode buttons light up,
and then release the button. The TV mode button begins to flash.
3. Press the STAR ( * ) button.
4. Enter the selected three-digit channel number. For example, if your remote
TV is set to use channel 3, enter 0-0-3 , or to use channel 4, enter 0-0-4 .
5. Press the POUND ( # ) button. The TV mode button flashes three times.
Programming the Recover Button
Your remote controls come equipped with a RECOVER button that helps you if
you accidentally change the channel or video input/source on your TV and
cannot get the video back from your satellite receiver. When you press the
RECOVER button as described on page 42, the remote control sends
commands to your TV to change channels or video inputs to try to return you to
watching satellite programming.
When an optional IR/UHF Pro remote control is shipped from the factory, the
RECOVER button is set up restore satellite TV viewing by tuning your TV first
to channel 3, then to 4, and then to other inputs (see page 42 for details). The
following instructions describe how to remove this programming from the
RECOVER button.
Removing the Recover Button Channel Programming
The following instructions describe how to reset the RECOVER button to the
way it was when the remote was delivered to you from the factory.
1. Press and hold the TV mode button until all the other mode buttons
light up, and then release the button. The TV mode button flashes.
2. Press the STAR ( * ) button.